Peugeot 2008 Bulb Replacement (2016-present)

Changing a bulb on your Peugeot 2008 is a job you can often do yourself, as long as you know which bulb goes where and how to reach it. This guide lists the front and rear lamps with their bulb types, explains how to change the ones you can replace yourself, and tells you which lamps need a PEUGEOT dealer or a qualified workshop.

Quick Reference

Changing a bulb

Before you change any bulb, read these safety points from the handbook. Some of the lamps get very hot, and the headlamp lenses can be damaged easily.

• Ignition and lamps off: only change a bulb with the ignition off and after the lamp has been switched off for several minutes. There is a risk of serious burns.
• Do not touch the glass: never touch the bulb directly with your fingers. Hold it with a lint-free cloth.
• Anti-UV bulbs only: use only anti-ultraviolet (UV) type bulbs, so you do not damage the headlamp.
• Same type and specification: always replace a failed bulb with a new one of the same type and specification.
• LED lamps: to replace light emitting diodes (LEDs), you must contact a PEUGEOT dealer or a qualified workshop.
• Halogen bulbs: check that the bulb sits correctly in its housing, so the lighting stays good.

The headlamps have polycarbonate lenses with a protective coating. To keep that coating and the seals in good condition:

• Do not clean the lenses with a dry or abrasive cloth, or with a detergent or solvent product.
• Use a sponge and soapy water, or a pH neutral product.
• If you use a high pressure washer on stubborn marks, do not keep the lance pointed at the lamps or their edges for too long.

In some weather, such as low temperature or humidity, misting on the inside of the headlamp and rear lamp glass is normal. It clears once the lamps have been on for a few minutes.

Front lamps

Here are the front lamps on your 2008 and the bulb each one uses.

You reach most of the front bulbs by opening the bonnet. If the engine is warm, take care, as there is a risk of burns. Keep objects and loose clothing away from the engine fan blades, as they could get caught and there is a risk of strangulation. After changing a bulb, close the protective cover very carefully so the lamp stays sealed.

Direction indicators

If an indicator lamp on the instrument panel flashes rapidly, one of the bulbs on that side has failed. Amber bulbs, such as the indicator bulbs, must be replaced with bulbs of the same colour and specification.

1. Turn the connector: turn it a quarter turn anti-clockwise.
2. Pull the connector: pull the bulb connector out.
3. Change the bulb: remove the bulb and fit a new one.

To refit, carry out these steps in reverse order.

Dipped beam headlamps

1. Remove the cover: pull on the tab to take off the protective cover.
2. Disconnect: unplug the bulb connector.
3. Release the bulb: spread the spring to free the bulb.
4. Change the bulb: pull the bulb out and fit a new one.

To refit, carry out these steps in reverse order, with the alignment lug at the bottom.

Main beam headlamps

1. Remove the cover: pull on the tab to take off the protective cover.
2. Disconnect: unplug the bulb connector.
3. Change the bulb: pull the bulb out and fit a new one.

To refit, carry out these steps in reverse order, with the alignment lug at the bottom.

Foglamps / directional lamps

1. Reach the lamp: get to the front foglamp through the opening below the bumper.
2. Disconnect: press on the top of the tongue to unplug the bulb holder connector.
3. Remove the holder: press the two clips (top and bottom) and pull out the bulb holder.
4. Replace the module: fit the new module.

To refit, carry out these steps in reverse order. You can get the module from a PEUGEOT dealer or a qualified workshop, who can also replace it for you.

Integrated direction indicator side repeaters

1. Insert a screwdriver: slide a flat screwdriver between the door mirror glass and its base.
2. Remove the glass: tilt the screwdriver and use it as a lever to take out the glass.
3. Remove the shell: press the two fixing clips to unclip the door mirror shell.
4. Remove the repeater: press the central tongue and take out the side repeater.
5. Change the bulb: pull out the bulb holder and replace the faulty bulb.

To refit, carry out these steps in reverse order. A PEUGEOT dealer or a qualified workshop can also do this for you.

Rear lamps

Here are the rear lamps on your 2008 and the bulb each one uses.

The third brake lamp also uses LEDs. To replace any LED lamp, contact a PEUGEOT dealer or a qualified workshop.

Number plate lamps

The lens is easier to remove with the tailgate half open.

1. Insert a screwdriver: put a thin screwdriver into the cut-out on the outside of the lens.
2. Lever it out: push the screwdriver outwards.
3. Remove the lens: take the lens off.
4. Change the bulb: replace the faulty bulb.

To refit, press the lens until it clips into place.

Foglamps and reversing lamps

To reach these bulbs, pass your hand under the bumper. On the left-hand side, do not touch the exhaust pipe, as there is a risk of burns if you change a bulb after stopping the engine.

1. Remove the holder: turn the bulb holder an eighth of a turn and pull it out.
2. Change the bulb: replace the faulty bulb.

To refit, carry out these steps in reverse order.

Frequently Asked Questions

Why is my Peugeot 2008 indicator flashing fast?

Rapid flashing of the left or right indicator lamp means one of the bulbs on that side has failed. Replace it with a bulb of the same colour and specification.

What bulb does the Peugeot 2008 dipped beam headlamp use?

The dipped beam headlamps use H7 bulbs, and so do the main beam headlamps. Use only anti-UV type bulbs, so you do not damage the headlamp.

Can I change the LED lamps on my Peugeot 2008 myself?

No. For LED lamps, such as the daytime running lamps, the rear brake lamps and the third brake lamp, you must contact a PEUGEOT dealer or a qualified workshop.

Is condensation inside my Peugeot 2008 headlamps normal?

Yes, in some weather, such as low temperature or humidity, misting on the inside of the headlamp and rear lamp glass is normal. It clears after the lamps have been on for a few minutes.

Most of the halogen bulbs on your Peugeot 2008 are quick to change once you know where they sit. Always let the lamps cool first, use the correct bulb type, and leave the LED lamps to a PEUGEOT dealer or a qualified workshop.

More Peugeot 2008 Guides

If a warning lamp comes on while you are driving, see our guides to the Peugeot 2008 red warning lights, the Peugeot 2008 orange warning lights and the Peugeot 2008 green and blue indicator lamps.

Don't forget to follow us on Instagram for more Peugeot guides!

Related guides: Peugeot 2008.