The alarm protects your car and deters theft and break-ins. It has three types of monitoring:
- Perimeter monitoring: the alarm goes off if anyone tries to open a door, the boot, the bonnet, etc.
- Volumetric monitoring: the alarm goes off if anyone breaks a window, enters the passenger compartment or moves inside the car.
- Self-protection: the alarm goes off if the battery, the central control unit or the siren wiring is put out of service or damaged.
For any work on the alarm system, contact a PEUGEOT dealer or a qualified workshop.
Locking with the full alarm system:
- Leave the car: switch off the ignition and get out.
- Arm: press the locking button on the remote control.
The red indicator lamp in the button flashes once per second. Exterior perimeter monitoring starts after 5 seconds and interior volumetric monitoring after 45 seconds. If a door, the boot or another opening is not closed properly, the car does not lock, but the perimeter monitoring starts after 45 seconds along with the volumetric monitoring.
Deactivating: press the unlocking button on the remote control. The indicator lamp in the button goes off.
Locking with exterior perimeter monitoring only: switch off the volumetric monitoring to avoid unwanted triggering, for example when you leave a pet in the car, leave a window partly open or wash the car.
- Ignition off: switch off the ignition.
- Within 10 seconds: press the button until its red indicator lamp stays on continuously.
- Get out: leave the car.
- Lock: immediately press the locking button on the remote control.
Only perimeter monitoring is now active and the red indicator lamp flashes once per second. You need to repeat this every time you switch off the ignition.
Reactivating volumetric monitoring:
- Unlock: press the unlocking button on the remote control to switch off the perimeter monitoring.
- Lock: press the locking button on the remote control to activate all the monitoring functions.
The red indicator lamp in the button flashes every second again.
When the alarm is triggered: the siren sounds and the direction indicators flash for 30 seconds. Monitoring stays active until the alarm has been triggered eleven times in a row. If the indicator lamp in the button flashes rapidly when you unlock with the remote control, the alarm went off while you were away. This flashing stops as soon as you switch on the ignition.
If the remote control is faulty:
- Unlock: use the key in the driver's door lock.
- Open the door: the alarm goes off.
- Ignition on: switch on the ignition to stop the alarm. The indicator lamp goes off.
Locking without the alarm: lock or deadlock the car using the key in the driver's door lock.
Malfunction: if the red indicator lamp in the button stays on when you switch on the ignition, the system is faulty. Have it checked by a PEUGEOT dealer or a qualified workshop.
Automatic activation: depending on the country of sale, the alarm activates automatically 2 minutes after the last door or the boot is closed. To avoid setting it off when you get in, press the unlocking button on the remote control first.
Electric windows
Each window has its own switch, and there is a separate switch to lock out the rear controls.
- 1: front left electric window switch.
- 2: front right electric window switch.
- 3: rear right electric window switch.
- 4: rear left electric window switch.
- 5: deactivates the rear electric window switches.
Manual operation: press or pull the switch without going past the point of resistance. The window stops as soon as you let go.
Automatic operation (depending on version): press or pull the switch beyond the point of resistance. The window opens or closes fully when you let go. Pressing the switch again stops the window.
The switches keep working for approximately one minute after you remove the key. After that, switch the ignition on again to use them.
Safety anti-pinch (depending on version): if the window meets an obstacle while rising, it stops and partly lowers again straight away. If the window opens unexpectedly while closing automatically:
- Open fully: press the switch until the window opens completely.
- Close: pull the switch straight away until the window closes.
- Hold: keep holding the switch for approximately one second after the window has closed.
The anti-pinch function is not active during this operation.
Rear window lockout: for your children's safety, press switch 5 to stop the rear door windows working, whatever their position. When the indicator is on, the rear controls are disabled. When it is off, they work.
Reinitialising after the battery is reconnected: the anti-pinch function must be reinitialised. It is not active while you do this.
- Lower: bring the window all the way down.
- Raise: bring it back up. It rises a few centimetres with each press, so repeat until the window is fully closed.
- Hold: keep pulling the switch upwards for at least one second after the window has closed.
Always remove the key when you leave the car, even for a short time. If a window meets an obstacle, reverse it by pressing its switch. When you use the passenger window switches, make sure nobody is stopping the windows closing properly, check that your passengers use the windows correctly and keep a close eye on children.
Panoramic glass sunroof
The panoramic tinted glass roof and its configurable light guides bring more light and visibility into the cabin. An electric blind improves temperature and acoustic comfort.
- Opening the blind: lift control A towards the rear. The blind stops when you let go.
- Closing the blind: push control A forward. The blind stops when you let go.
If the blind meets an obstacle, reverse it by pressing the control. When you operate the blind, make sure nobody is stopping it closing properly, check that passengers use it correctly and take particular care with children.
Frequently Asked Questions
How do I unlock my Peugeot 2008 if the remote key stops working?
Turn the key in the driver's door lock towards the front of the car. This does not switch off the alarm, so it goes off when you open the door, and switching on the ignition stops it.
Why won't my Peugeot 2008 lock with the remote?
The central locking does not take place if a door or the boot is still open. The remote control also does not work while the key is in the ignition, even with the ignition switched off.
How do I leave my dog in my Peugeot 2008 without setting off the alarm?
Switch off the ignition, then within 10 seconds press the button until its red indicator lamp stays on, get out and lock the car straight away with the remote control. Only perimeter monitoring stays active, and you need to repeat this each time you switch off the ignition.
What do I need to do with the electric windows after reconnecting the battery?
You must reinitialise the anti-pinch function. Lower each window fully, raise it in steps until it is closed, then keep pulling the switch for at least one second.
Knowing how your Peugeot 2008 key, doors, boot and alarm work makes everyday use easier and helps keep your car and your passengers safe. For full details on any feature, ask a PEUGEOT dealer or a qualified workshop.
More Peugeot 2008 Guides
If a warning lamp comes on, see our guides to Peugeot 2008 red warning lights, Peugeot 2008 orange warning lights and Peugeot 2008 green and blue indicator lamps.
Don't forget to follow us on Instagram for more Peugeot guides!
This is an independent guide, not an official Peugeot publication. If in doubt, contact a PEUGEOT dealer or a qualified workshop before carrying out any work.
Related guides: Peugeot 2008 model guides.
Cover adapted from a photograph by Vauxford — Wikimedia Commons, CC BY-SA 4.0 (AI edited).