Peugeot 208Updated 10 min read

Peugeot 208 I Gauges and Service Indicator

Peugeot 208 service indicator reset, coolant temperature gauge, oil level indicator and AdBlue range warnings explained.

Peugeot 208 (2015-present) in town at blue hour with an indicator flashing
Image adapted from a photo by Harvey Bold, CC0.

Hello and welcome. In this post, we'll look at the gauges and the service indicator on the Peugeot 208 I (2015-present). Your Peugeot 208's instrument panel does more than show your speed. It tells you when the next service is due, whether the engine coolant temperature is correct, what state the engine oil level is in and, on BlueHDi Diesel versions, how far you can drive before you need to top up the AdBlue. Some indicators depend on the version or equipment fitted, so you may not see all of them on your 208.

How do I reset the service indicator on my Peugeot 208?

Switch off the ignition, press and hold the trip distance recorder reset button, then switch the ignition back on. Let go of the button when “=0” appears and the spanner disappears.

Peugeot 208 I service-indicator reset using the trip-distance reset button
Service-indicator key or spanner symbol on the instrument panel, with the remaining distance or time

Quick Reference

Scroll the table sideways.

SectionIn short
Service indicatorDistance to next service, reset and recall steps
Engine coolant temperatureNeedle zones and what to do if too hot
Engine oil level indicatorOil level display, low level and fault messages
AdBlue range indicatorsAdBlue and SCR range warnings before starting is prevented

Service indicator

The service indicator appears on the instrument panel. Depending on your car's version, it shows the information in one of two ways:

  • Distance recorder display line: shows the distance remaining before the next service, or the distance travelled since the service was due, with a “-” sign in front.
  • Alert message: shows the distance remaining, plus the time left before the next service or how long the service is overdue.

Scroll the table sideways.

LampStateMeaningWhat to do
Service spannerLights up temporarily when you switch on the ignition.Between 620 and 1,860 miles (1,000 and 3,000 km) remain before the next service is due.-
Service spannerFixed when you switch on the ignition.The service is due in less than 620 miles (1,000 km).Have your car serviced very soon.
Service spanner flashingFlashes then stays fixed when you switch on the ignition. On BlueHDi Diesel versions, it comes on with the Service warning lamp.The servicing interval has been exceeded.Have your car serviced as soon as possible.

The distance shown, in miles or kilometres, is worked out from the distance covered and the time passed since the last service. The alert can also come on when you are close to a due date.

The service indicator must be reset after every service. If you have serviced the car yourself, reset it like this:

  1. Ignition off: switch off the ignition.
  2. Hold the button: press and hold the trip distance recorder reset button.
  3. Ignition on: switch on the ignition. The distance recorder display starts a countdown.
  4. Release: let go of the button when “=0” appears. The spanner disappears.

If you need to disconnect the battery after doing this, lock the car and wait at least 5 minutes so the reset is registered.

You can check the service information at any time. Press the trip distance recorder reset button and the information appears for a few seconds, then disappears.

Engine coolant temperature

With the engine running, the coolant temperature gauge needle tells you whether the engine coolant temperature is correct.

  • Zone A: the engine coolant temperature is correct.
  • Zone B: the engine coolant temperature is too high. The maximum temperature and central STOP warning lamps come on, with an audible signal and a warning message on the screen.

If the needle reaches zone B:

  1. Stop: stop as soon as it is safe to do so.
  2. Wait: wait a few minutes before switching off the engine.
  3. Get help: contact a PEUGEOT dealer or a qualified workshop.

Engine oil level indicator

On versions with an electric oil level indicator, the engine oil level appears on the instrument panel for a few seconds, straight after the service information. The reading is only correct if the car is on level ground and the engine has been off for more than 30 minutes.

Oil level insufficient: the message “Oil level incorrect” appears on the instrument panel screen, with the Service warning lamp and an audible signal. Check the level with the dipstick. If it confirms the level is low, top up the oil to avoid damaging the engine. Check the fluid levels, or ask a PEUGEOT dealer or a qualified workshop.

Oil level indicator fault: the message “Oil level measurement invalid” appears on the instrument panel. Contact a PEUGEOT dealer or a qualified workshop.

Bear in mind that when the electric indicator is faulty, the oil level is no longer monitored. You must check the engine oil level yourself with the manual dipstick under the bonnet, as described for checking the fluid levels, or ask a PEUGEOT dealer or a qualified workshop.

AdBlue range indicators

These range indicators are only fitted to BlueHDi Diesel versions. Once the AdBlue® tank is on reserve, or after a fault with the SCR emissions control system is detected, an indicator shows an estimate of how far you can drive before engine starting is prevented. It appears when you switch on the ignition.

The engine starting prevention system required by regulations switches on automatically once the AdBlue® tank is empty. When the range is greater than 1,500 miles (2,400 km), no range information appears automatically when you switch on the ignition, but pressing the relevant button shows the driving range for a short time.

Scroll the table sideways.

Remaining rangeEngineWhen you switch on the ignitionWhile driving
Between 1,500 and 500 miles (2,400 and 800 km)1.5 litre BlueHDi euro 6.2AdBlue warning lamp comes on for about thirty seconds, with the message “Top up AdBlue: Starting prevented in x miles/km”.-
Between 1,500 and 500 miles (2,400 and 600 km)1.6 litre BlueHDi euro 6.1AdBlue warning lamp comes on, with an audible signal and a message such as “Top up AdBlue: Starting prevented in x miles”.Message appears approximately every 200 miles (300 km) until you top up.
Between 500 and 62 miles (800 and 100 km)1.5 litre BlueHDi euro 6.2AdBlue warning lamp comes on, with an audible signal (1 beep) and a message such as “Top up AdBlue: Starting impossible in x miles”.Audible signal and message every 62 miles (100 km) until you top up.
Less than 350 miles (600 km)1.6 BlueHDi euro 6.1AdBlue warning lamp flashes, the Service warning lamp stays on, with an audible signal and a message such as “Top up AdBlue: Starting impossible in x miles”.Message every 30 seconds until you top up.
Less than 60 miles (100 km)1.5 BlueHDi euro 6.2AdBlue warning lamp flashes, with an audible signal (1 beep) and a message such as “Top up AdBlue: Starting impossible in x miles”.Audible signal and message every 6 miles (10 km) until you top up.

In the first two stages, the reserve level has been reached and you should top up as soon as possible. In the last three stages, you must top up as soon as possible and before the tank is completely empty, otherwise you will not be able to restart the engine after your next stop.

Breakdown from lack of AdBlue®: when you switch on the ignition, the AdBlue warning lamp flashes, with an audible signal and the message “Top up AdBlue: Starting impossible”. The tank is empty and the starting prevention system required by legislation stops the engine from starting. To restart the engine, you must add at least 5 litres of AdBlue® to the tank. see the AdBlue® (BlueHDi engines) section below for how to top up.

Fault with the SCR emissions control system: once a fault is confirmed, a system that prevents engine starting switches on automatically after 685 miles (1,100 km). Have the system checked by a PEUGEOT dealer or a qualified workshop as soon as possible.

  • Fault detected: the related warning lamps come on, with an audible signal and the message “Emissions fault”. The alert appears while driving when the fault is first detected, then each time you switch on the ignition while the fault persists. If the fault is temporary, the alert disappears during your next journey, after the SCR system has run its self-diagnosis.
  • Permitted driving phase, between 685 and 0 miles (1,100 and 0 km): the fault is confirmed after 30 miles (50 km) with the fault message permanently displayed. The warning lamps come on and the AdBlue warning lamp flashes, with an audible signal and a message such as “Emissions fault: Starting prevented in 185 miles (300 km)” showing the remaining range. While driving, the message appears every 30 seconds while the fault persists, and the alert repeats when you switch on the ignition. Go to a PEUGEOT dealer or a qualified workshop as soon as possible, otherwise you will not be able to restart the car.
  • Starting prevented: each time you switch on the ignition, the warning lamps come on and the AdBlue warning lamp flashes, with an audible signal and the message “Emissions fault: Starting prevented”. You have gone past the authorised driving limit and the engine cannot be started. Call a PEUGEOT dealer or a qualified workshop to get it started.

Frequently Asked Questions

How do I reset the service indicator on my Peugeot 208?

Switch off the ignition, press and hold the trip distance recorder reset button, then switch the ignition back on. Let go of the button when “=0” appears and the spanner disappears.

What does the minus sign on the Peugeot 208 service indicator mean?

A “-” sign in front of the distance means the service is overdue. The figure shows the distance travelled since the service was due.

How much AdBlue do I need to restart my Peugeot 208 after the tank runs empty?

You must add at least 5 litres of AdBlue® to the tank before the engine will restart.

What does “Oil level measurement invalid” mean on a Peugeot 208?

It means the electric oil level indicator has a fault, so the oil level is no longer monitored. Check the level with the dipstick under the bonnet and contact a PEUGEOT dealer or a qualified workshop.

Your 208's gauges and indicators give you early notice of servicing, overheating, low oil and AdBlue levels, so it pays to know what each one shows. Keep this guide handy. If in doubt, ask a PEUGEOT dealer or a qualified workshop.

More Peugeot 208 Guides

For what each lamp on your dashboard means, see our guides to Peugeot 208 red warning lights, Peugeot 208 orange warning lights and Peugeot 208 green and blue indicator lamps.

Don't forget to follow us on Instagram for more Peugeot guides!

This is an independent guide, not an official Peugeot publication. If in doubt, contact a PEUGEOT dealer or a qualified workshop before carrying out any work.

Related guides: Peugeot 208 model guides.

Cover adapted from a photograph by Harvey Bold — Wikimedia Commons, CC0 (AI edited).

Related guides

Guide ·

Peugeot 208 AdBlue Refilling (2015-present)

BlueHDi Diesel engines on the Peugeot 208 use AdBlue to clean up their exhaust gases. This guide explains what the SCR system does, how far you can drive on a tank of AdBlue, how to store and handle the fluid s…

Guide ·

Peugeot 208 12 V Battery and Jump Starting (2015-present)

A flat 12 V battery is one of the most common reasons a car will not start. This guide explains how to reach the battery on your Peugeot 208, how to start the engine using another battery or a booster, how to c…